2360862166E – 6R2-PM-51.7-460-120-W-US-Lead
The 6-inch permanent magnet motor is engineered for high performance, simple startup and incredible long-term cost savings. Based on field trial data, owners and operators benefit from electrical cost savings as a result of 90% efficiency rating in the motor for an investment payback of less than two years in typical duty rate applications. Each MagForce High Efficiency System is powered with a permanent magnet motor that operates at a fraction of the energy consumption when compared to traditional induction systems. Plus, each 6-inch permanent magnet motor is paired with an innovative Franklin Electric engineered drive for intuitive startup and reliable protection for submersible pumping applications.
| Item: | 2360862166E |
| Model: | 6R2-PM-51.7-460-120-W-US-Lead |
| Type | Sand Fighter |
Ratings |
||
| Frequency | 120 Hz | |
| Phases | Three-Phase | |
| Amps - Full Load | 74 A | |
| Amps - Service Factor | 80 A | |
| Volts | 460 VAC | |
| Voltage Tolerance (%) | -10.0% / +10.0% | |
| Wire | 3-Wire | |
| Thrust Bearing Rating | 6000 lb | |
| Lead Length | 13 ft | |
| Motor | Encapsulated | |
| Continuous Duty | Yes | |
| Efficiency Service Factor Load [%] | 91.50 % | |
| Protection [IP] | IP68 | |
| Lead Wire Size | AWG #8 | |
| Lead Retainer Method | Lead Jam Nut | |
| Motor Insulation Classification | F | |
| Poles | 4 | |
| Service Factor - 120Hz | 1.15 | |
| VFD Required | YES | |
| HP | 40-60 hp | |
| Motor Cooling | Water | |
| Minimum Cooling Flow | 1.6 ft/sec | |
| Motor Ambient Temperature Rating Nominal | 86 °F | |
| Thrust Bearing Rating | 6000 lb | |
| Motor Adapter | Double flange | |
| Rotation | Counter clockwise facing the shaft | |
| SubTrol Heat Sensor | NO | No |
Materials of Construction |
|
| Motor Shaft End - Material | Stainless Steel 1.4462 |
| Thrust Bearing | Kingsbury |
| Seal | Mechanical Seal SiC/SiC |
| Lead Insulation Material | EPR |
| Diaphragm Material | Nitrile Rubber (NBR) |
| Motor Bottom End Bell Material | Cast Iron with E-Coat Paint |
| Motor Fill Solution (Water Soluble / Non Toxic) | YES |
| Motor Fill Solution | FES91 |
| Motor Top End Bell Material | Cast Iron with E-Coat Paint |
| Shaft Slinger Material | Nitrile Rubber (NBR) |
| Stator Ends Material | Carbon Steel |
| Stator Fill | Resin |
| Stator/ Motor Shell Material | 304SS |
| Winding Material | Copper |
Dimensions |
|
| Motor Diameter - Physical Diameter | 5.44" |
| Motor Length | 40.18 " |
| Product Weight | 172 lb |
| Product Weight with Pack | 185 lb |
| Carton Length | 47.24 " |
| Carton Width | 6.1 " |
| Carton Height | 8.35 " |
| Shaft Diameter | 1 " |
| Shaft End | Spline |
Other |
|
| Drinking Water Agency Approvals | ANSI/NSF Standard 61 |
| Electrical Agency Approvals | UL |
| Warranty Standard Time | 12 Mo. from Date of Install / 24 Mo. from Date of Manufacturing |
